JLG 3246E2 ANSI Service Manual - Manual (Page 55)

SECTION 2 - PROCEDURES
3120737 – JLG Lift – 2-41
2.23 MACHINE MODEL DEFAULT SETTINGS
Table 2-5. Machine Model Default Settings Chart
Adjustment 2632E2/3246E3
DRIVE ACCELERATION 1.0 sec
DRIVE DECELERATION 0.5 sec
DRIVE CREEP 12 %
DRIVE SPEED MAX (LOW) 100 %
DRIVE SPEED MAX (HIGH) 85 %
ELEVATION MAX* 42%*
POSITRAC TIME 10 sec
HIGH DRIVE OVER CURRENT 140 amps
HIGH DRIVE TIME OUT* 5.0 sec**
LIFT ACCEL 1.0 sec
LIFT DECEL 0.0 sec
LIFT CREEP 15%
LIFT UP MAX 100 %
DECK ACCEL 0.5 sec
DECK DECEL 0.0 sec
DECK CREEP 10%
DECK EXTENSION SPEED MAX. 10%
DECK RETRACTION MAX 80%
STATIC STEER 30%
STEER (DRIVE COMP) 15 %
GROUND LIFT UPMAX 100%
GROUND DECK IN MAX 50%
GROUND DECK OUT MAX 40 %
NOTE: WARNING: Changing the machine model will set all person-
alities back to the factory default settings. check the machine
model adjustment chart for the correct settings for each
model. if your machine does not match the proper settings
for each model, adjust the settings as necessary in accor-
dance with the chart.
NOTE: * JLG strongly recommends that these settings not be
changed. Changing these settings may adversely affect the
performance of your machine.