Brother CS 80 - Manual (Page 4)

———————————————————————————————————————— Names of Machine Parts and Their Functions
Cover C
Needle and presser foot
section
1 Buttonhole lever
Lower the buttonhole lever when sewing buttonholes
and bar tacks.
2 Needle bar thread hook
Pass the upper thread through the needle bar thread
hook.
3 Needle plate
The needle plate is marked with guides for sewing
straight seams.
4 Bobbin cover/shuttle
Remove the bobbin cover, and then insert the bobbin
into the shuttle.
5 Feed dogs
The feed dogs feed the fabric in the sewing direction.
6 Presser foot
The presser foot applies pressure consistently on the
fabric as the sewing takes place. Attach the appropriate
presser foot for the selected stitching.
7 Presser foot holder
The presser foot is installed onto the presser foot holder.
Right-side/rear view
1 Handle
Carry the sewing machine by its handle when
transporting the machine.
2 Balance wheel
Turn the balance wheel toward you to raise and lower
the needle to sew one stitch.
3 Main power switch
Use the main power switch to turn the sewing machine
on and off.
4 Power supply jack
Insert the plug on the power supply cord into the power
supply jack.
5 Foot controller jack
Insert the plug on the end of the foot controller cable
into the foot controller jack.
6 Air vent
The air vent allows the air surrounding the motor to be
exchanged. Do not cover the air vent while the sewing
machine is being used.
7 Feed dog position switch
Use the feed dog position switch to lower the feed dogs.
Memo
● Refer to Cover B, D or E pages while you
are learning to use your machine.
1
2
3
4
5
6
7
1
2
5
3
4
6
7
S2_brotherE.book Page C Thursday, February 13, 2003 11:03 AM