JLG 18RS Service Manual - Manual (Page 17)

SECTION 1 - SPECIFICATIONS
3121284 – JLG Lift – 1-5
1.3 OPERATOR MAINTENANCE
NOTE: The following numbers correspond to those in Fig-
ure 1-1., Operator Maintenance and Lubrication
Diagram.
LUBRICATION INTERVALS ARE BASED ON MACHINE OPERATION
UNDER NORMAL CONDITIONS. FOR MACHINES USED IN MULTI-
SHIFT OPERATIONS AND/OR EXPOSED TO HOSTILE ENVIRON-
MENTS OR CONDITIONS, LUBRICATION FREQUENCIES MUST BE
INCREASED ACCORDINGLY.
1. Swing Bearing - Internal Ball Bearing
Lube Point(s) - 2 Grease Fittings
Capacity - A/R
Lube - MPG
Interval - Every 3 months or 150 hrs of operation
Figure 1-1. Operator Maintenance and Lubrication Diagram
Table 1-10. Lubrication Specifications.
KEY SPECIFICATIONS
BG* Bearing Grease (JLG Part No. 3020029) Mobilith SHC
460.
HO Hydraulic Oil. API service classification GL-4, e.g. Mobil-
fluid 424.
EPGL Extreme Pressure Gear Lube (oil) meeting API Service
Classification GL-5 or Mil-Spec Mil-L-2105.
MPG Multipurpose Grease having a minimum dripping point of
350° F (177° C). Excellent water resistance and adhesive
qualities, and being of extreme pressure type.
(Timken OK 40 pounds minimum.)
EO Engine (crankcase) Oil. Gas - API SF, SH, SG class, MIL-
L-2104. Diesel - API CC/CD class, MIL-L-2104B/MIL-L-
2104C.
*MPG may be substituted for these lubricants, if necessary, but ser-
vice intervals will be reduced.