Eppendorf Excella E-10 Classic Platform Shaker - Manual (Page 13)

Installation
New Brunswick Excella® E-10 Open Air Shaker
English (EN)
13
1. Using the 7/32 inch hex wrench provided, remove the four Allen head platform screws from the upper
bearing housing.
Abb. 4-1: Upper bearing housing with platform screw locations (top view)
Fig. 4-1: Upper bearing housing with platform screw locations (top view)
2. Place the platform on the UPPER BEARING HOUSING. Align the mounting holes of the platform with
the platform screw locations in the upper bearing housing.
3. Insert the four Allen head platform screws previously removed, and tighten them with the 7/32 inch hex
wrench provided to secure the platform.
4.5 Install flask clamp
Flask clamps purchased for use with universal platforms require installation (see Universal platform flask
capacity on p. 31). Clamps are installed by securing the base of the clamp to the platform with the correct
type and number of screws. All clamps are shipped complete with hardware.
Clamps for 2 L, 2.8 L and 4 L flasks are shipped with an additional girdle to keep the flasks in place. The
girdle is an assembly of springs and sections of rubber tubing. One girdle is already in place on the clamp,
the other is packed separately.