Eppendorf Mastercycler pro - Manual (Page 65)

System management
Mastercycler pro
English (EN)
65
 Make the settings in the header(see Editing header settings on p. 42).
 Press the OK function key.
The editor is displayed.
 Press the >> function key and then Save .
You can start the program without renewed optimization of the parameters.
Setting from the Mastercycler 533x
program Corresponding setting in the program header
LID 105 °C Lidtemp 105 °C
Wait TSP/ESP heated lid
AUTO Switch off lid at low block temperature
CNTRL BLOCK = Temp. mode block
TUBE = Temp. mode safe or fast
Block temperature control behavior Activate the Simulate Mastercycler gradient checkbox