Aries Automotive P1050 - Manual

PARTS LIST:
Qty Description Qty Description
1 Grille Guard 20 12mm x 24mm OD x 2.5mm Flat Washers
1 Driver/Left Frame Mounting Bracket 10 12-1.75mm Nylon Lock Nuts
1 Passenger/Right Frame Mounting Bracket 2 10-1.5mm x 30mm Button Head Bolts
1 Driver/Left Top Mounting Bracket 4 10mm x 20mm OD x 2mm Flat Washers
1 Passenger/Right Top Mounting Bracket 2 10mm Nylon Lock Nuts
2 8mm Special Rod Bolts 2 8mm x 28mm OD x 3mm Large Flat Washers
10 12-1.75mm x 30mm Hex Bolts 2 8mm Nylon Lock Nuts
2 8mm Clip nuts 2 8mm Button head bolts
2 8mm Flat washers 2 8mm lock washers
1 Support flange
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. CUTTING IS REQUIRED. ASSISTANCE IS
RECOMMENDED.
2.
Starting under the front bumper of the vehicle, remove the plastic top fill plate between the bumper
and the radiator. Also remove the lower factory splash guard. Place both on a clean, stable work
surface.
3.
Select the passenger side Frame Mounting Bracket. Bolt the Frame Mounting Bracket to the
bottom of the cross member with (1) 12mm x 30mm Hex Bolt, (2) 12mm Flat Washers and (1)
12mm Nylon Lock Nut. NOTE: 07-09 models will use the outer mounting location (Fig 1A), and
2010-13 models
will use the inner mounting location, (Fig 1B). Insert (1) 12mm x 30mm Hex Bolt,
(2) 12mm Flat Washers and (1) 12mm Nylon Lock Nut through the upper tab on the side of the
Mounting Bracket upright and tighten hardware at this time, (Fig 2). Repeat this step to install the
driver side Frame Bracket, (Fig 1C).
4.
Next, place the top fill plate back in position and mark a slot on the underside straight up from the
frame upright, (the top brackets slide into the frame upright-see Fig 5). Cut (2) slots to clear the
Top Brackets, (Fig 3). NOTE: Only cut a slot large enough to clear the Top Mounting Brackets.
Driver/Left Top
Mounting Bracket
Driver/Left Frame
Mounting Bracket
Passenger/Right Frame
Mounting Bracket
(2) 8mm Rod Bolts
Passenger/Right Top
Mounting Bracket
INSTALLATION INSTRUCTIONS
2007-13 JEEP WRANGLER
PART# P1050
Support Flange
(2) 8mm Nut Clips