Aries Automotive P3063 - Manual (Page 8)

Driver Side Installation Pictured
Fig 16
Insert a 10mm Plastic Washer between the
Grille Guard and the slotted Top Bracket.
Line up the hole in the Plastic Washer with
the mounting holes. Insert the Quick
Release Bolt through the Plastic Washers Front
Place a 10mm Plastic Washer
between the slotted Top Bracket and
the 10mm Flat Washer to protect the
finish on the Top Support Bracket.
Inside of upright on Grille Guard
pictured
Fig 17B Front
Non tow hook model pictured. Once Grille Guard has been
completely installed and lined up properly on the vehicle, tighten
only the hardware bolting the Frame Brackets to the frame. Remove
the Grille Guard. Hold the plastic lower bumper cover up in the
original position against the Brackets. Trace the Frame Bracket
locations onto the cover. Cut out the area with sharp knife of
hacksaw blade. Cut as little as possible from cover. Do not cut
through top or bottom edge. Cut area pictured for example only.
Installer responsible for correct modifications
Fig 17A
Fig 18
Do not cut through
top or bottom edge
of bumper cover
Front
Special 10mm
Pivot Washer
Page 8 of 9 11/12/2013