Aries Automotive P3063 - Manual (Page 7)

Driver Side Installation Pictured
Fig 13
12mm x 35mm Hex Bolt
12mm Lock Washer
12mm Flat Washer
Protect the top of the plastic bumper
cover with masking tape to prevent
scratches during installation
For easier installation, insert (1) 12mm Hex Bolt,
(2) 12mm flat washers (1) 12mm lock washer per
side in the location pictured in Fig 8 to act as a
hinge.
Insert 12mm Plastic Washers between the Grille
Guard and the Mounting Bracket. Line up the holes in
the Plastic Washers with the mounting holes. Insert
the Mounting Bolts through the Plastic Washers
Fig 14
(2) 12mm x 35mm Hex bolts
(2) 12mm Lock Washers
(2) 12mm Flat Washers
Front
Fig 12B
Fig 15
Front
Front
Use factory hex bolt
Cover a section (dotted line) of the
bottom of the Bracket with Foam Tape
to prevent damage to finish on bumper
Fig 12A
Snug the hardware
but do not tighten,
then rotate the Grille
Guard up into
position
Page 7 of 9 11/12/2013