Snorkel AB85RJ CE - Manual (Page 41)

Chapter 7 – Prestart Inspection
AB80J/AB85J – 0420453EE 37
Figure 7.20 – Upper Control Panel Front
Plug an electrical tool into the receptacle at the platform
and at the generator and try to operate the tool to verify
proper operation of the outlet.
Drive Motion Alarm
The machine may be equipped with an optional drive
motion alarm. Drive in both the forward and reverse direc-
tions to ensure that the alarm sounds to warn personnel
in the area that the aerial platform is in motion.
Platform Control Cover
The machine may be equipped with an optional platform
control cover. Inspect the cover to ensure it fits properly
over the control panel.
Driving and Work Lights
The machine may be equipped with driving lights and/or
platform work lights. Turn the engine on and use the
switch on the back of each light to momentarily turn it on
to see that it works.
Platform Glazier Package
Inspect the glazier trays (refer to Figure 7.2) and keeper
pins to make sure they are in good condition and are not
bent or distorted. The straps and padding must be in good
condition and not worn, cut or frayed.
Figure 7.21 – Platform Glazier Package
Placards and Decals
Inspect all safety and operational placards and decals.
Make certain they are in place, in good condition, and
are legible.
The placards and decals may be cleaned with soap and
water, and a soft cloth if the words or pictures cannot be
seen.
A Caution
Solvents may contain hazardous ingredients. Follow
the manufacturer’s label for proper use and disposal.
Wear protective gloves and splash-proof safety
glasses when using solvents.
Wet paint overspray may be removed using a natural
biodegradable solvent and a soft cloth.
Replace any missing or illegible placards or decals before
operating the aerial platform. Placard and decal kits are
available from Snorkel.
The safety related placards and decals are illustrated on
the following pages.
Padding
Trays
Straps
Keeper Pins
Machine/Generator Switch