Snorkel A38E-sn006001+ - Manual (Page 34)

Chapter 8 – Prestart Inspection
30 A38E – 8210243
Electrical Power Outlet
To test the electrical power outlet:
1. Connect a source of 110 volt AC power to the power-
input connector on the right side of the chassis (refer
to Figure 8.18).
Figure 8.18 – Power-Input Connector
2. Plug an electrical tool into the receptacle at the
platform and try to operate the tool to verify proper
operation of the outlet.
The outlet is equipped with a ground fault circuit inter-
rupter (GFCI). Use the following procedure to test the
GFCI.
1. Push the test button (refer to Figure 8.19).
Figure 8.19 – Electrical Power Outlet
2. Plug an electrical tool into the outlet and verify the
power is off.
If the power was off, push the reset button to
restore power.
If the power was on, repair or replace the re-
ceptacle.
•
•
All Motion Alarm
The machine may be equipped with an optional all mo-
tion alarm.
Operate the machine functions to ensure that the
alarm sounds to warn personnel in the area that the
aerial platform is in motion.
Placards and Decals
To inspect the placards and decals:
1. Inspect all safety and operational placards and de-
cals. Make certain they are in place, in good condi-
tion, and are legible.
2. Clean the placards and decals with soap and water,
and a soft cloth if the words or pictures cannot be
seen.
Caution
Solvents may contain hazardous ingredients. Follow
the manufacturer’s label for proper use and disposal.
Wear protective gloves and splash-proof safety
glasses when using solvents.
3. Remove wet paint overspray with a natural biode-
gradable solvent and a soft cloth.
4. Replace any missing or illegible placards or decals
before operating the aerial platform.
Placard and decal kits are available from Snorkel.
The safety related placards and decals are illustrated on
the following pages.
•
Power-Input Connector
Test Button
Reset Button