Snorkel A38E-sn006001+ - Manual (Page 17)

Chapter 4 – Safety Devices
A38E – 8210243 13
Attach only one fall restraint device to each lanyard
anchor.
Do not use the aerial platform for personal fall
arrest anchorage.
Tilt Alarm
If the aerial platform chassis is out of level more than five
degrees when the main boom is raised or extended, or
when the riser boom is raised, an alarm will sound. The
tilt alarm is located under the upper control panel.
Danger
The aerial platform can tip over if it becomes unstable.
Death or serious injury will result from a tip-over ac-
cident. Do not drive or position the aerial platform for
elevated use near any drop-off, hole, slope, soft or
uneven ground, or other tip-over hazard.
Completely lower the booms and then drive to a level
surface when the tilt alarm sounds.
The tilt alarm is for added protection and does not
justify operating on anything other than firm, flat, level
surfaces.
Horn
The horn may be used to warn personnel on the ground.
The horn switch is to the right of the emergency stop
button on the upper control panel (refer to Figure 4.8).
The horn is operational when the machine is set up for
operation from the upper controls.
Figure 4.8 – Upper Controls
•
•
All Motion Alarm
The all motion alarm sounds, in short beeps, anytime the
machine functions are being operated. The alarm is used
to warn personnel in the work area to stand clear.
Flashing Light
An amber flashing light may be located on the top of the
turntable. The flashing light warns personnel that the
aerial platform is in the area.
The light flashes at approximately one flash per second
when the machine is set up for operation from either the
lower or upper controls.
Horn