Snorkel X26N-sn51089+V-1 - Manual (Page 19)

Page 15
9 MAINTENANCE
9 MAINTENANCE
W A R N I N G ! !
Never perform service while the platform is elevated without first blocking the elevating assembly. DO NOT
stand in the elevating assembly area while deploying or storing the brace.
BLOCKING THE ELEVATING ASSEMBLY
SCISSOR BRACE
INSTALLATION
Park the machine on a firm, level 1.
surface.
Pull Chassis Emergency Stop Switch to
2.
the ON position.
Pull Platform Emergency Stop Switch to
3.
the ON position.
Turn and hold the Chassis Key Switch
4.
to CHASSIS.
Push the Chassis Lift/Lower Switch to
5.
LIFT to elevate the platform until the
scissor brace can be rotated to the
vertical position.
From the rear of the machine, lift the
6.
scissor brace from its stowed position.
Rotate upward and outward, then down
until it is hanging vertically below its
attachment point.
Lower the platform by pushing the
7.
Chassis Lift/Lower Switch to LOWER
and gradually lower the platform until
the scissor brace is supporting the
platform.
SCISSOR BRACE STORAGE
Using the Chassis Controls, gradually 1.
elevate the platform until the scissor
brace is clear.
Rotate the scissor brace outward and
2.
upward over its mounting point until it
rests in the stowed position.
Lower the platform by pushing the
3.
Chassis Lift/Lower Switch to LOWER to
completely lower the platform.
Figure 10: Scissor Brace
Rotate Brace
Clockwise to
Block
Counterclockwise
to Store
Brace Rests
on Weldment
when in
Blocking
Position
Rotate Brace
Clockwise to Block
Counterclockwise to
Store
Brace Rests
on Weldment
when in Blocking
Position