Snorkel UL20-sn17745+ - Manual (Page 5)

5
The battery box is heavy, 76 lbs. (34.5 kg),
lift properly (or have someone help you) to
prevent back injury.
Make sure loader fully engages tailgate or
vehicle bed.
LOADING
1. Raise the loader support bracket and engage the
retaining pin in the top hole of the loader
channel (Figure 7).
2. Secure the loader to the loader support bracket
with the gravity hook (Figure 7).
3. Position the unit so the back of the machine
comes in contact with the vehicle bed or tail-
gate.
4. Release the retaining pin and slide the loader
down until it comes into contact with the
vehicle bed or tailgate (Figure 7). Reposition the
loader support bracket so the retaining pin is in
the first available hole above the loader.
5. Remove loading handle from storage position
on left side of mast. Secure loading handle in
loading position in base of unit using clevis pin.
(Figure 6).
6. Lift up on the loading handle, using the loader
as a pivot until the unit rotates to a horizontal
position in the vehicle bed (Figure 8).
Loaders
DC MODELS
Disconnect the plug from the battery box and
remove the battery box from the rear of the ma-
chine (Figure 5).
Figure 7: Loader in load position
7. Push the base of the unit towards the front of
the vehicle bed. The machine will slide on the
loader until the rear wheels are on the bed. The
unit may then be rolled on the rear wheels and
upper wheels.
8. Return the loading handle to the stored position.
9. Secure the unit with suitable strength rope or
tie straps.
To prevent damage to the mast assembly,
do not place rope or tie straps across the
mast assembly when securing the unit for
transportation.
DO NOT overtighten the rope or tie straps,
damage to the machine will result.
Figure 6: Installing loading handle
Retaining Pin
Loader Support
Bracket
Tailgate
Loader Channel
Gravity Hook
Loader
Loading Handle
Storage Position
Clevis Pin
Loading Handle