Snorkel SB126J - Manual (Page 41)

Chapter 7 – Prestart Inspection
SB126J – 0192278 35
Emergency Stop
Push the emergency stop button in to turn off the engine.
The upper control functions should not operate with the
emergency stop in this position.
Emergency Power
Pull the emergency stop button out and place the anti-
restart master switch in the on position.
Hold the engine/emergency power switch in the emer-
gency power position and step on the platform foot
switch to operate the aerial platform from the upper
controls using the emergency power system.
Horn
Press the horn button (refer to Figure 7.28) to ensure
that it sounds to warn personnel in the area.
Figure 7.28 – Upper Control Panel
AC Generator
The machine may be equipped with an optional hydraulic
powered AC generator. With the engine running, place
the machine/generator control (refer to Figure 7.28) in
the generator position to provide electrical power to the
outlet at the platform and to the outlet on the end of the
generator housing.
Plug an electrical tool into the receptacle at the platform
and at the generator and try to operate the tool to verify
proper operation of the outlet.
Horn
Machine/Generator Switch
Drive Motion Alarm
The machine may be equipped with an optional drive
motion alarm. Drive in both the forward and reverse
directions to ensure that the alarm sounds to warn per-
sonnel in the area that the aerial platform is in motion.
Driving and Work Lights
The machine may be equipped with driving lights and/or
platform work lights. Turn the engine on and use the
switch on the back of each light to momentarily turn it
on to see that it works.
Platform Control Cover
The machine may be equipped with an optional platform
control cover. Inspect the cover to ensure it fi ts properly
over the control panel.
Placards and Decals
Inspect all safety and operational placards and decals.
Make certain they are in place, in good condition and
are legible.
The placards and decals may be cleaned with soap and
water, and a soft cloth if the words or pictures cannot
be seen.
A
Caution
Solvents may contain hazardous ingredients. Fol-
low the manufacturer’s label for proper use and
disposal. Wear protective gloves and splash-proof
safety glasses when using solvents.
Wet paint overspray may be removed using a natural
biodegradable solvent and a soft cloth.
Replace any missing or illegible placards or decals
before operating the aerial platform. Placard and decal
kits are available from UpRight distributors.
The safety related placards and decals are illustrated
on the following pages.