Snorkel MB20-sn1000+ - Manual (Page 24)

2 - 14
2. Operation & Specifications
T
RANSPORT BY
T
RUCK
The MB20N/26 can be carried on a suitably rated transportation vehicle or trailer.
Because of its high gradeability, the machine can be driven under its own power on to
a standard loading ramp (Up to 14 degrees).
It is recommended to reverse the machine up on to the truck thus forward travelling
down the ramp at the delivery point. Winch-assisted loading is allowable for larger
slopes, however, operate the trucks assist winch at minimum speed to avoid over-
pressurising the hydraulic system in the machine.
When the MB20N/26 is on the truck or trailer it should then be made secure by:-
1. Chocking the wheels.
2. Securing with adequate chains or straps to the lifting lugs on the chassis.
Figure 5: Securing the Platform
T
OWING
& W
INCHING
V
ALVES
The fail-safe brakes are automatically applied when the machine comes to a stop or
in the event of total power loss due to low battery or malfunction of the hydraulic drive
system.
To tow the vehicle or to winch it on to a truck it is necessary to hydraulically bypass
the control valves and release these brakes.
Make sure the Jib is tied down securely during transport, DO NOT over tighten
straps. Straps should have adequate slack so no downward force is applied to the Jib.
C A U T I O N ! !
DO NOT loop straps through the cage, ladder or jib as this could
cause permanent structural damage during transportation.