Snorkel AB48HSRT-sn4611+ - Manual (Page 25)

23
3. EMERGENCY SLEW
If a loss in power has occurred, the slew can be operated by hand. To do
this:
Wind out spindle on right hand side of
hydraulic manifold block
Locate 17mm socket (located in vehicle tool box) on to slew drive hex shaft
and rotate as required to position slew the machine.
Before operating this machine, it is important that both the
Operator and another responsible person on site, is aware of the
position and function of the following:
A) Emergency Stop Buttons.
B) Emergency Lowering Buttons.
C) Emergency Slew Drive Shaft.
EMERGENCY CONTROLS
SECTION
L
Ensure that the spindle is wound in fully for normal use once the
problem has been rectified.
Spindle