Snorkel AB48HSRT-sn4611+ - Manual (Page 13)

11
The following Pre-Start Checks should be carried out before taking the
machine to the place of work.
1.
Damaged or Loose Fittings.
Visually Inspect the whole machine for signs of wear and tear, damage,
loose or missing parts.
2. Wheels.
Check tyres are at the correct pressure, AB48HSRT = 58psi (4 bar).
3. Hydraulic
fluid.
The hydraulic oil tank is located below the foot well on the left hand side of
the vehicle. With the booms and outriggers in the transport position, the
hydraulic oil level should be visible between the upper and lower marks on
the dipstick.
Top up with ISO Grade 22 hydraulic oil if necessary.
4.
Safety Switches.
Check all switches are free from damage and move easily
With outriggers in transport position, it must not be possible to operate the
extending structure.
With outriggers deployed, under load and the bottom boom raised
approximately 50mm, it must not be possible to operate the outrigger
controls.
Serious injury or even death may result by not carrying out the
following checks of the interlock system before the platform is
used!
Do Not Overfill the Tank
1
PRE START CHECK
SECTION
F