Synergy 8562 - Dodge AAM 9-1/4'' Inner Axle Sleeve Kit - Manual (Page 2)

7) Remove the unit bearings and axle shafts.
8) Remove the shocks, sway bar links, coil springs, driveshaft, draglink, track bar and all control arms at
the housing. This will allow for removal of the complete housing.
9) On the short side of the axle housing; Drill holes as shown in Figure 1&2 below. Drill 2 holes on the
front side, back side and bottom side of the tube axle tube. The factory coil and control arm bracketry
prohibits drilling and welding on the top side of the axle tube.
Figure 1