Synergy 8555-10 - Dodge HD Front Lift Coils - Manual (Page 2)

7) With coil springs removed, remove the shock. Due to the long free length of the 8555-10 coil, it is
easier to install the coil and shock together as one or to remove the factory upper shock mount and
install shock from the top once the coil has been installed.
8) Install the coil so the part number is oriented the right way up. The tighter winds of the coil should be at
the top. Retain the factory coil spring isolator. Be sure to install the 8555-10-HD-R on the passenger
side, and the 8555-10-HD-L on the driver side of the truck.
 Note – upper control arm bolt removal at the axle may be necessary to allow the front
suspension to drop out enough for coil spring installation.
9) Index spring so that the end of wrap aligns with the edge of lower coil perch as shown below.
10) Reinstall all removed components during installation.
11) Note, sway bar links on older trucks can be flipped to the top mounts of the axle as shown below.