Synergy 8516-XX-XXX - Dodge Add-A-Leaf Pack 94+ Dodge Trucks - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
INSTALLATION INSTRUCTIONS
PPM-8516 DODGE ADD-A-LEAF PACK
GENERAL NOTES:
• These instructions are also available on our website at www.synergymfg.com Check the
website for any updated instructions and additional photos for reference.
• These add a leaf packs are designed to replace the factory overload spring for an
improved ride both on and off road.
• The installation of this pack will affect the truck’s load carrying characteristics when the
factory overload is removed. The owner will notice more “squat” in the rear when
carrying heavy loads. If large loads are frequently hauled, we suggest adding some form
of airbag kit in conjunction with this kit for optimum ride and load carrying
characteristics.
• This is a bolt on installation and can be done with simple hand tools, some quality C-
clamps, a jack and jackstands.
• The following installation is done on 2010 CTD 2500 4x4 truck. Installation on other
Dodge applications will be similar.
• **NOTE** If your truck is equipped with square u-bolts which wrap around the leaf
spring as shown below, you will need to re-use the existing u-bolts or purchase a PPM-
3127-300 U-bolt spring plate to utilize the new U-bolts provided in the kit.