Synergy 8079 - Jeep JK Front Sway Bar Quick Disconnect Kit - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-8079 JK FRONT SWAY BAR DISCONNECT KIT
Version 1.1
GENERAL NOTES:
• These instructions are also available on our website; www.synergymfg.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.
• This sway bar quick disconnect kit was designed to use in conjunction with the
Synergy Suspension sway bar link relocation brackets (PPM-8010) or front track
bar relocation bracket (PPM-8088 & PPM-8089)
• You will need to ream or drill the hole in the end of the sway bar for the rod end
to ½”
**NOTE**
• Remove the steel tube sleeves from the bushing ends of your sway bar links before
beginning installation.
INSTALLATION WITHOUT TRACK BAR RELOCATION BRACKET
1. Remove the factory sway bar links.
2. Run a 1/2” drill bit or reamer through each side of the stock sway bar holes to enlarge
the holes for the new rod end studs.
3. Attach the sway bar end link relocation brackets to the factory sway bar end link tab
on the axle using the 1.5” long spacer and ½” x 3” bolt. Use a flat washer under the
bolt head and lock nut. The picture below shows the driver side relocation bracket;
assemble the passenger side opposite of this.