Synergy 8080 - Jeep JK Rear Track Bar Bracket Brace - Manual (Page 3)

5) Once all bolts are started (with the exception of the countersunk bolt which requires drilling) tighten
the 9/16” TB bolt to fully locate bracket. Do not overtighten to the point of bending the stock TB
mount. Simply tighten to the point as to not allow the TB brace to move, this will locate the bracket
to make sure the TB bolt can still be removed easily for serviceability.
 Tighten the other 3 bolts to fully locate TB brace.
 Mark and center punch the hole for the countersunk bolt. (We recommend removal of
the new TB brace prior to drilling to prevent damage to powder coat, but the hole can be
drilled at this time without removing brace.)
6) Remove TB brace and drill 7/16” diameter hole.
7) Deburr hole and reinstall TB brace in the same order and procedure as before.