Synergy 8075 - Jeep JK Front Track Bar - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-8075 JK FRONT TRACK BAR
V2.0
GENERAL NOTES:

These instructions are also available on our website; www.synergymfg.com. Check the website before
you begin for any updated instructions and additional photos for your reference.

The installation of this adjustable track bar will allow you to correctly align the front axle after a
suspension lift kit is installed.

The track bar features a double adjuster sleeve which allows you to adjust the length of the track bar
without removing the end of the track bar from the vehicle.
1. The track bar is pre assembled with all the necessary components.
2. Installation of the track bar can be performed with the vehicle sitting on level ground.
3. Remove the existing track bar, a 21mm wrench and socket will be required.
4. Install the new adjustable track bar with the bend upwards with the bushing at the frame end and the
adjustable rod end at the axle end.
5. Re-use the stock track bar mounting bolts and torque to 125 ft-lbs, the frame bolt must be installed from
front to rear. It helps to have someone turn the steering wheel to help align the bushing to the bracket hole
when inserting the bolt.
6. Center the axle by turning the adjuster sleeve, counterclockwise will extend the track bar. Use a ¼” punch
or similar tool to turn the adjuster sleeve. Once you have the axle centered tighten the pinch bolt to 80 ft-
lbs.
a. After tightening the pinch bolt, try ty spin the adjuster sleeve. Make sure the pinch bolt has
adequately clamped onto the rod end shank so that the adjuster is not movable.
7. Grease the polyurethane frame pivot bushing with quality automotive chassis grease through the attached
zerk fitting.