Synergy 8060 - Jeep JK Rear Sway Bar Links - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
8060 – JEEP JK REAR SWAY BAR LINKS
GENERAL NOTES:

These instructions are also available on our website; www.synergymfg.com. Check the website before
you begin for any updated instructions and additional photos for your reference.

Installation can be done with simple hand tools and vehicle sitting on ground under its own weight.
However installation is much easier with suspension at full droop and both rear tires removed. Use a
quality jack and jack stands whenever working under a vehicle.
PARTS LIST:

PART NUMBER – PART DECRIPTION
 (2) 806001 JK rear sway bar links assembled with tie rod end & jam nut
 (2) ½-20 UNF top lock flange nut
Parts / Tools Needed to complete installation:

Basic simple hand tools.
o
Wrench / socket sizes: 14mm, 15mm, 18mm, ¾”
INSTALLATION:
1) Remove the factory sway bar links. 18mm socket / wrench.
2) Make sure the new sway bar links are roughly the same length left to right by adjusting the tie rod ends.
On lifts 4.5” or less, adjust tie rod ends all the way down.
3) Install sway bar link to axle using factory hardware as shown. Insert bolt from wheel side and fasten
with nut on inner side. Torque to 75 ft-lbs.