Synergy 8054 - Jeep JK Rear Upper Control Arms - Manual (Page 2)

5. Tighten the factory control arm bolts to 125 ft-lbs, once final length adjustments are
made, tighten the pinch bolt to 50 ft-lbs.
6. Grease the flex joints using extreme pressure moly grease.
7. We recommend that you over fill the rear differential oil when increasing the pinion
angle. The front bearing will not be submersed in oil and damage may result. You
can use an aftermarket differential cover with a higher fill plug or just add additional
oil through the vent tube fitting in the passenger side axle tube. Adding an additional
1-2 qts of gear lube should be sufficient.