Synergy 8012-14 - Jeep JK HD Front LCA Bracket: Stock Axle - Manual (Page 4)

6. Position the passenger side bracket opposite. The easiest way is to measure from the
machined edge adjacent to the weld on the inner C. Measure the driver side then
make the passenger side bracket the same dimension. The dimension should be close
to 5 ¼ to the outside edge of the new lower control arm bracket. Tack weld into
place.
7. Fully weld the lower control bracket to the axle tube. Weld along the front edge and
sides. Wrap the weld around the back edges at least ½ along the inner edge. You
will have to weld the inner edge on the driver side bracket that is adjacent to the diff
housing.
8. The lower control arm brackets have two mounting positions. The lower hole is the
stock location; you can move the lower control arms to the upper hole and trim the
bottom for more ground clearance.