Synergy 5804 - Jeep TJ/LJ Front Grab Handle Set - Manual (Page 2)

1) Remove A-pillar windshield trim if vehicle is equipped with it by first removing the
sun visor.
a. Next, remove upper side window frames by unscrewing top dial fasteners.
b. Remove the outer torx head bolt (T-40) which connects the B-pillar to a-
pillar. This is your forward attachment point for the grab handles.
c. Unscrew the three Phillips head screws that run down the length of the a-
pillar trim.
d. Remove the sun visors. There is one screw holding them in.
e. Trim should be loose at this time, to fully remove, locate plastic barb
fastener at top of trim and pry free. Pull the trim away from the windshield
as there is a small clip by the sun visor attachment which holds it in place.
(See pictures below)