Synergy 5716-01 - JK Diesel HD Transmission Cross Member 07+ - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-5715-01 (GAS)
PPM-5716-01 (DIESEL)
Jeep JK Heavy Duty Replacement Cross Member
Version 1.1
GENERAL NOTES:

These instructions are also available on our website; www.synergymfg.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.

The 5715-01 cross member is designed to be compatible with stock skid plates as
well as many aftermarket skids which were designed to fit the factory cross
member on 2007-2013 Jeep JK vehicles with gas drive trains (3.8L or 3.6L
Pentastar).

The 5716-01 cross member is designed to be compatible with stock skid plates as
well as many aftermarket skids which were designed to fit the factory cross
member on 2007-2013 Jeep JK vehicles with diesel drive trains.

This installation will cover the installation on a Jeep equipped with a gas powered
engine, using factory skidplates. Installation will be similar if aftermarket skid
plates are used or if installing on a diesel model jeep.
PARTS LIST:

(1) 5715-01 (GAS) or 5716-01 (DIESEL) JK HD Replacement Cross Member

(5) ½-13 UNC x 1.0” long Gr8 hex head bolt
 (5) ½” Flat Washer Gr8
INSTALLATION
1. Begin by removing the transfer case and transmission skidplate if equipped.
 All factory skidplates use the same hardware which can be
removed with an 18mm socket or wrench.
 Remove bolts labeled 2, 3, 5 and 6 in Image 1.1 below to remove
the factory skidplates.