Synergy 5011 - Jeep JK Front Coil Over Mounting Kit - Manual (Page 11)

You may need to trim the back of the track bar bracket to clear the new lower shock
bracket.
6. Position the new upper shock brackets on the frame, the brackets are left and right
specific so you will need to determine which side is which by fitting them to the
frame. We recommend that you paint the upper mount before you tack weld into
place. Leave the areas that you will be welding unpainted.
a) The rear edge of the upper shock bracket should be located along the front edge of
rectangular hole for the brake line bracket.
b) The top of the upper shock mount should fit up in the pocket where the stock
shock bracket was located. When the upper shock bracket is correctly
positioned, tack weld into place, then repeat on the other side.