Synergy 4040 - Synergy Sit Shower Shave Kit - Manual (Page 12)

11) Next, measure the amount of hose needed to go from each fitting to the heat exchanger. Cut the
appropriate length of hose and hook up to the heat exchanger as shown below.
12) Secure the new coolant lines to the motor using the factory spring clamps. Secure the hoses to the brass
fittings on the heat exchanger with the hose clamps provided in the kit.
Reconnect any intake components or other various parts removed for installation and
refill the cooling system. Be sure to bleed out any air bubbles in the cooling system and
check for leaks before moving onto the next step.