Synergy 4018 - Jeep JK Compressor Mount - Manual (Page 3)

3
Jeep JK Compressor Mount Kit
Viair 400H or 450 Series
Installation Instructions Supplement
Kit Contents:
(4) M5 X 20mm Machine Screws (4) M5 Serrated Flange Nuts
Required Tools: - 4mm Allen wrench - Measuring device (ruler or dial caliper, etc)
- 3/16” drill bit - Center Punch
11. With a 4mm Allen Wrench and the supplied fasteners (One foot on the 400H gets flipped and
both feet on the 450 Series get flipped) flip and re-mount the feet brackets as indicated in the
following two pictures:
400H - The foot flip procedure for the 400H is complete at this time. Proceed with the standard
compressor mount bracket instructions at this time.
12. With both feet flipped on the 450, mount the compressor on the bracket as indicated in the previous
picture.
13. Slide the compressor as far to the front of the mounting slots as possible and mark the rear two holes
to be drilled.
14. Center punch and drill the rear holes.
15. The foot flip procedure is now complete. Proceed with the compressor mount bracket instructions at
this time.