Lukas P 630 Lite - Manual (Page 22)

22
7.2.3 Commissioning (after the fi rst fi lling or prior to use)
1. Check the
À uid level of the engine oil, the hydraulic À uid and the fuel reservoir. Top up if
necessary. For precise reading of the
À uid levels and for ¿ lling, the hydraulic unit should
be as level as possible.
2. Now connect the extension hoses and/or hose reels (unless already connected to the unit)
and/or couple the rescue equipment.
Before starting the combustion engine, check that the fuel tank is full and that the engine oil
level is within the permitted tolerances. If necessary, top up the relevant
À uid.
1. Open petrol tap
2. Set the ON/OFF switch to the ON position.
3. Move lever from switching position A to switching
position B (choke) when starting from cold
4. Pull starter cable.
5. When the engine is running, switch the lever back to
position A.
For the detailed procedure for starting the
combustion engine, please see the
separate operating instructions of the engine manufacturer!
ATTENTION!
The control lever of the hydraulic power unit should always be switched to the
neutral position (depressurized) prior to starting the engine in order to prevent
unwanted movements of connected hydraulic equipment and starting the power
unit without hydraulic load.
B
A
8.1 Starting the engine
8. Operation