CompuSTAR RF-2W940-SS (Remote 2W940R-SS) - Manual (Page 7)

13 By Firstech, LLC
General System Functions
The remote transmitter functions have been predetermined and programmed from the factory. The four button configuration allows for many functions to be
performed through a series of tapping, holding and / or multiple presses of buttons.
Sending Commands
When in range and a command has been sent, the remote will receive a page back and LED confirmation. For example, to send a remote start command from the
2 Way remote, hold down the button for 2.5 seconds. The remote will beep once to confirm the command has been sent and that the remote is in range.
Once the vehicle has successfully remote started, the remote will receive a command indicating the vehicle is running.
Receiving Commands
The remote pager will receive commands indicating the status of the vehicle, confirmation of sending commands and alarm notifications. For example, after
sending the lock command, the pager will receive LED and chirp signals confirming that the vehicle has been successfully locked/armed. To see if your pager is in
range, hold the buttons for 2.5 seconds - if the remote receives an audible and visual confirmation then it is in range.
By Firstech, LLC 14
General System Functions
Tap button for a half second to lock/arm and unlock/disarm. The LED will flash on your remote. If your vehicle is locked, tap button to unlock; if your
vehicle is unlocked, tap button to lock.
IMPORTANT: If the alarm has been triggered (Siren is going off), you must wait up to 5 seconds before disarming the alarm - the first button tap will
shut off the alarm and the second will unlock/disarm the system.
aƒ”‰– @lƒ‹@O@a’@Ž„@uŽŒƒ‹@O@d‰“’
The system can be configured to passively lock and arm the vehicle. Put the system in passive by tapping buttons simultaneously for a half
second. The remote will beep once and the LEDs will illuminate to indicate the system is in passive lock and arming mode.
While in passive mode, the system will lock and arm the alarm 30 seconds after the last door is closed. As an indicator that the vehicle is going to passively lock
and arm, the remote and siren will chirp once and the parking lights will flash once at both 10 and 20 seconds prior to passively locking and arming. If you want
the system to passively arm and not passively lock, ask your local Firstech dealer to turn Option 1-8 to setting III.
p““‰– @lƒ‹@O@a’