General system functions – CompuSTAR RF-2W940-SS (Remote 2W940R-SS) User Manual
Page 10
General System Functions
To silent your remote you must turn on vibration mode;
STEP 1: Enter remote programming mode by holding the Unlock and Trunk buttons simultaneously for 2.5 seconds. The remote will beep 4 times
and the Lock and Unlock LEDs will flash on your remote indicating that you have successfully entered programming mode.
STEP 2 : Tap the Unlock button. The Unlock LED will change to blue indicating that vibrate is on. Tap the Unlock button again to turn vibrate off. Two chirps
and Unlock LED flashes indicates vibrate is off.
STEP 3: Exit remote programming by holding down the Unlock and Trunk buttons simultaneously for 2.5 seconds.
The remote will beep indicating that you have successfully exited programming. Your remoteᴗs LEDs will still illuminate but remote will vibrate to show 2 Way
confirmation.
r @m @O@v@m
Hold the Lock and Trunk buttons simultaneously for 2.5 seconds to turn the shock sensor on and off. The remote will beep twice, trunk icon
will illuminate and lock icon flash twice showing the sensor is off. The remote will beep once, trunk icon will illuminate and lock icon flash once showing
the sensor is on.
IMPORTANT: Turning off the shock sensor also turns off any optional sensors.
Adjusting the shock sensor sensitivity is done at the actual sensor, which is generally mounted somewhere under the vehicleᴗs dashboard. The higher the
number on the dial means greater sensitivity to impact. The recommended dial setting for most vehicles is somewhere between 2 & 4. If you are testing
your sensor, please note that the shock sensor does not recognize impact for 30 seconds after the system has been armed.
s@s @o@O@o
19 By Firstech, LLC
By Firstech, LLC 20
General System Functions
Your SLICE remote comes with an automatic button lock feature. This feature automatically locks all four buttons on your SLICE remote after one minute. To
unlock just tap any button then tap or hold the button(s) for the command you would like to send. This feature must be turned on in the Remote Option Menu.
STEP 1: Enter remote programming mode by holding the Unlock and Trunk buttons simultaneously for 2.5 seconds. The remote will beep
5 times and the Lock and Unlock LEDs will flash on your remote indicating that you have successfully entered programming mode.
STEP 2 : Tap the Start button. One chirp and Start LED flash indicates that Automatic Button Lock is on. Tap the Start button again to turn
Auto Button Lock off. Two chirps and LED flashes indicates the feature is off.
STEP 3: Exit remote programming by holding down the Unlock and Trunk buttons simultaneously for 2.5 seconds. The remote will beep
indicating that you have successfully exited programming.
a@b@l