Apple PC Compatibility Card (Installation) - Manual (Page 21)

5 Slip the cable clamp over the three folds in the internal PC audio/video assembly cable.
Then pinch the open ends of the cable clamp to close it and hold the folds in place.
6 Make sure the folded cable lies flat along the top of the card.
If necessary, pinch the folds in the cable more to flatten the folded cable.
The folded, clamped cable should
not rise up above the bottom of
the sheet metal tabs on the vertical
plate (approximately 3/32" below
the top of the vertical plate). Sheet metal tabs on
vertical plate
(Side view) Vertical plate Logic board connector
Folded, clamped cable
Pinch the open
ends of the cable
clamp to close it.
Cable clamp
Make sure the tab on the
cable clamp is on this side
of the cables and points down.
21 Installing the PC Compatibility Card in a 5400 Series Macintosh Computer