Apple Power Mac G4 (Gigabit Ethernet) - Manual (Page 60)

60 Chapter 4
5 Install the ATA drive in the U-shaped bracket.
Note: The tinted screws illustrated below indicate the four low-profile screws that came in
the computer’s accessory kit. The untinted screws show the screws that came with the new
drive.
Attach an additional ATA drive (1" high)
to the upper portion of the drive carrier
by screwing it into position on its sides.
Attach the two screws on this side first.
These two
tabs will
bend
inward as
you tighten
these two
screws.
ATA drives that are 1" high are attached
to the lower portion of the drive carrier
from the bottom.
Position the hard disk drive on the drive carrier so that the ribbon cable connector and the
power cord connector are accessible.