Apple Xserve Intel (Late 2006) DIY Procedure for Rear ID Tab - Manual (Page 18)

Xserve (Late 2006) Rear ID Tab Replacement Instructions 1
Rotate the top of the holder to the closed position.
Engage the latch on the metal processor holder.
Holding the heat sink in one hand, reconnect the 2-pin thermal sensor cable for the left
processor (CPU B) heat sink to the logic board.
Note: Make sure the connector on the sensor cable is oriented as illustrated, with the gold
fingers facing up.
Carefully seat the heat sink over the processor, aligning the four screws with the holes in the
logic board.
9.
10.
11.
12.