Bosch AXXUS WFL 2050 - Manual (Page 34)

34
WARNING
To reduce the risk of fire or electrical shock,
DO NOT use an extention cord or an adapter to
connect the washer to the electrical power
supply.
In the event that an earthĆleakage circuit breaker is
to be used, only use types marked with the
following symbol: 7.
Only this symbol can guarantee compliance with all
current regulations.
Do not insert / remove the mains plug with wet or
damp hands.
Handle the plug body only when removing the plug
from the socket.
Transport, e.g. when moving
Before transporting the washing machine:
- Turn off the water tap,
- Drain any residual water (refer to page 20),
- Release the water pressure in the supply hose
(refer to page 22),
- Disconnect the washing machine from the
mains.
- Dismantle the supply and drainage hose,
- Install the lower 2 transport bolts.
Having transported the appliance and ensured
proper installation and connection, allow the Drain
program to run through before starting the first
wash program.
Preparing and inserting the transport bolts
q Remove the 2 lower covers.
q Prepare the transport bolts:
Loosen the screw in the sleeve until the end of
the screw is level with the end of the sleeve.
q Insert and tighten transport bolts 1 and 2. The
lug on the washing machine must be located in
the groove in the rear panel of the housing.