Bosch AXXUS WFL 2050 - Manual (Page 31)

31
Hose and cable lengths
LeftĆhand connection
approx. 39"
(100 cm)
approx. 56½"(145 cm)
approx. 35" (90 cm)
max.
39"
(100
cm)
RightĆhand connection
approx. 48¾" (135 cm)
max.
39"
(100
cm)
approx. 56½"
(145 cm)
approx. 39" (100 cm)
Other hoses
Available from specialty dealers:
- Extended supply hose (approx. 2.2 m //
86.6 in).
Water connection
Water supply
CAUTION
The washing machine must only be operated
with cold and hot (max. 140 °F // 60 °C) tap
water. Do not connect the appliance to the mixer
tap of an unpressurized hotĆwater boiler.
If in any doubt, have the water connection carried
out by an authorized technician.
The water supply hoses must not be:
- Bent or squashed.
- Modified or cut through (stability can no longer
be guaranteed).
Plastic threads must only be tightened by hand.
Do not remove the strainers from the water supply
hoses.
Observe the water pressure in the supply network:
- The water pressure should be between 14.5 to
145 p.s.i. (1 to 10 bars) (when the tap is turned
on, at least 2.2 U. S. gallons (8 liters) of water is
discharged per minute).
- A pressure reducing valve must be installed if
the maximum water pressure is exceeded.
CAUTION
To protect against water demage, the hot and
cold water valves should be accessible when the
washer is in place and should always be turned
off when the washer is not in use.
When washer is being installed in new construcĆ
tion, or a building that has had its plumbing sysĆ
tem recently installed or upgraded, the lines
must be flushed prior to installing the washer.
This must be done to clear the lines of any sand,
dirt or residue that may still be in the lines.