Troubleshooting minor faults, Risk of electric shock – Bosch AXXUS WFL 2050 User Manual
Page 24
24
Troubleshooting Minor Faults
d
RISK OF ELECTRIC
SHOCK!
d
Repairs must only be carried out by our
Customer Service or an authorized technician.
If repairs are needed, and assuming that you
cannot eliminate the fault yourself with the aid of
the following table:
q Turn the program selector to Off.
q Disconnect the washing machine from the
mains.
q Turn off the water tap.
q Call Customer Service (refer to page 23).
Fault
Cause
Action
The loading door cannot be
no final spin was selected.
Select Drain or Spin.
g
opened.
Safety function is active.
Wait for 2 minutes.
Detergent residue in the
detergent dispenser.
Detergent was damp or lumpy.
Clean and dry the detergent dispenser
(refer to page 19).
Use the dispensing aid for liquid detergents.
Control lights do not come on.
A fuse has triggered.
Call Customer Service replace the fuse.
g
Power failure.
An interrupted program will be resumed when
power returns. If you wish to unload the
laundry, proceed as in Cleaning the drain
pump", page 20.
Plug is loose or not inserted.
Insert the plug.
Program does not start.
f
Loading door not closed.
Check whether laundry is trapped in door.
g
The ready control light flashes.
g
Close the loading door (a click should be
heard).
Program does not start.
Start button not pressed.
Press the Start button.
Water does not enter the
Water tap not turned on.
Turn on water tap.
machine or detergent is not
washed away
Supply hose kinked or trapped.
Eliminate the cause.
washed away.
Strainer in supply hose clogged.
Clean the strainer (refer to page 22).
Water cannot be seen in drum.
This is not a fault.
The water lies below the visible part of the drum.
Water is not completely drained. Loose debris is blocking the pump.
Clean the pump (refer to page 20).
p
y
LintĆproducing laundry was washed. The water
drainage pipe or drain hose is blocked.
Clean the water drainage pipe and/or drain
hose.
Water is flowing out from
The thread of the supply hose is not tight.
Tighten the thread.
g
underneath the machine.
Leak in the drain hose.
Replace the drain hose.