Bosch AXXUS WFL 2050 - Manual (Page 25)

25
Fault Action Cause
Foam coming out of the
detergent dispenser.
Too much detergent. Mix 1 tablespoon of fabric softener with ½ litre
/ 1 pt of water and pour into chamber I of the
detergent dispenser.
Use detergent recommended for high effiĆ
ciency and frontĆloading washers.
Reduce the amount of detergent next time.
The laundry was not spun Large items of clothing became entangled and
could not be distributed evenly in the drum.
For safety reasons, the highĆspeed final spin
cycle was automatically cancelled.
Always load large and small items together
into the drum (see also unbalanced load
detection system).
Spin result unsatisfactory. Spin program selected - maximum spin speed 800 r.p.m.
Repeated spinning at short
intervals.
This is not a fault.
The imbalance compensation system is attempting to balance the load through repeated spins.
The program takes longer than
usual.
This is not a fault.
Unbalanced load detection system attempts to
distribute the washing evenly by spinning it
several times.
Always load large and small items together
into the drum.
The foam detection feature has activated an
additional rinsing cycle to reduce the amount
of foam.
Add a more appropriate amount of detergent
next time.
Unsatisfactory washing result. The degree of dirt was higher than supposed. Select a more suitable program. y g
Not enough detergent. Add detergent according to the manufacturer's
specifications.
Detergent residue on the laundry. Some phosphateĆfree detergents contain
waterĆinsoluble residues that may appear as
light spots on the laundry.
Brush off spots when laundry is dry.
Grey residues on the laundry. Dirt accumulation from ointments, fats or oils. Add the maximum amount of detergent and
select the highest permissible temperature
next time.