Apple Macintosh Performa 6300CD Series - Manual (Page 70)

The pointer ( 8 ) doesn’t move when you move the mouse.
One of the following situations is probably the cause.
m There is a software problem. Try the following:
Press x-Option-Esc to quit the application program in use when the
problem occurred. If this works, you can save the documents open in other
programs before restarting.
Restart your Macintosh. See “Start Over” in the section “If You Have
Trouble” earlier in this chapter for instructions.
m Follow the suggestions in the previous section, “A Dialog Box With a Bomb
Appears.”
m The mouse is not connected properly.
Turn the computer off using the standby power button, check that the
mouse and keyboard cables are connected properly, and then restart the
computer.
IMPORTANT Do not connect or disconnect the mouse while the computer is
turned on. You may damage your computer.
m Signals from the mouse are not reaching the computer, either because the
mouse needs cleaning or because there is something wrong with the
mouse.
Clean the mouse according to the instructions in Appendix A of this book.
If you have another mouse or pointing device, try connecting and using it.
(Turn the computer off before connecting it.) If the new device works, there
is probably something wrong with the mouse you replaced.
If none of these procedures solves the problem, consult the service and
support information that came with your computer for instructions on how to
contact an Apple-authorized service provider or Apple for assistance.
60 Chapter 6