Apple Xserve Intel (Late 2006) DIY Procedure for Front Panel Board Cable - Manual (Page 3)

Xserve (Late 2006) Front Panel Board Cable Replacement Instructions
Removing the Installed Front Panel Board Cable
Note: Before you can remove the front panel board cable, you must remove the airflow duct and
left PCI riser.
Airflow Duct
Loosen the five Phillips screws that fasten the airflow duct to the fan array.
Pull up on either side of the airflow duct, and lift it straight up and out of the Xserve.
Caution: Try not to completely remove the screws from the airflow duct. Tiny black rubber
washers hold these screws captive on the underside of the airflow duct. If the screws are
completely removed, these washers can easily fall into the enclosure and become lost.
1.
2.