JB Conversions 2308 Dana 300 - Manual (Page 20)

20
33) Install the yoke, rubber nut seal, and lock nut. Torque to #180 lb-ft
(Fig.40). Discard setup nut used in step 16.
FIG: 40
34) Remove the input retainer assembly you installed temporarily in step 15
(Fig.41).
FIG: 41
35) If you have left the slider ring, forks, and shift tower assembly in place
(from step #6) throughout this reassembly, apply RTV to the back of the
input retainer assembly and reinstall it. If you have removed the slider ring