Class1 Throttle Interface CAT 105216 - Manual (Page 8)

8
DOC 105216_e:\manuals\throttles\cat\New_CAT_Throt.p65-04252000
Operation
For questions or concerns regarding the interface module, call Class1
==
at 352-629-5020
FAX 352-629-2902
When the throttle interface module is powered up, it performs a self check and the module
then outputs an idle PWM signal of 12 % if the throttle is in the closed position.
The interface will verify that the throttle is not open more than half way. If the throttle is open
more than half way, the interface module will not increase the PWM until the throttle is closed
to less than half way.
When finished operating the remote throttle, the operator should return the throttle to idle and
turn the control to it’s full clockwise position. This will insure a zero throttle position.
NOTE: Caterpillar Engines perform their own idle validation for remote throttle operations.