Rock-Slide Engineering Ford Super Duty Rear Bumper User Manual
Page 5
Installation Instruction RSEI 115
7. Install factory license plate lights in new bumper
8. Plug stock wiring harness into sensors and license plate lights. Bumper is now ready to install
9. Place bumper on vehicle. Bolt bumper to mounting brackets, using provided ½” bolts, washers
and nylock nuts. Adjust so the tailgate opens and closes without hitting the bumper and so the
light pockets or step are not touching the truck. When fit properly, tighten bumper bolts and
bolts from the bracket to the frame
See also other documents in the category Rock-Slide Engineering For the car:
- RIGID SERIES FRONT BUMPER (4 pages)
- RIGID SERIES REAR BUMPER (7 pages)
- TJ FRONT BUMPER (3 pages)
- TJ REAR BUMPER (8 pages)
- TJ CRAWLER FRONT BUMPER (2 pages)
- Step Slider Door Delete Kit (4 pages)
- TJ YJ LJ STEP SLIDER (8 pages)
- JEEP JK4 STEP SLIDER (10 pages)
- JEEP JK2 STEP SLIDER (9 pages)
- RIGID SERIES SKID PLATE (2 pages)
- JK4 SLIDER (4 pages)
- JK2 SLIDER (3 pages)
- Rigid Rack (3 pages)
- TAILGATE TABLE (5 pages)
- TJ WINCH PLATE (2 pages)
- RIDGE FRONT BUMPER BULL BAR LIGHT KIT (3 pages)
- R-SE JK BOMBSHELL KIT (2 pages)
- 3rd BRAKE LIGHT KIT (3 pages)
- Ford Super Duty Step Slider (14 pages)
- FORD VAN STEP SLIDER (5 pages)
- Ford F-250, F-350, F-450 Front Bumper (5 pages)
- STEP-SLIDER MAINTENANCE (1 page)
- STEP SLIDER MOTOR REPLACEMENT (4 pages)
- JK – VACUUM PUMP RELOCATION (3 pages)
- PATRIOT SERIES – FRONT BUMPER (4 pages)
- PATRIOT SERIES – REAR BUMPER (2 pages)
- RAPTOR – STEP SLIDER (12 pages)
- RAPTOR – SLIDER (5 pages)
- PATRIOT SERIES – SKID PLATE (2 pages)
- RAPTOR – WINCH PLATE (1 page)
- PATRIOT SERIES – WINCH PLATE (2 pages)
- RAPTOR – SPARE TIRE CARRIER (4 pages)
- TUNDRA SERIES – STEP SLIDER (12 pages)
- RAM STEP SLIDER (13 pages)