Rock-Slide Engineering Ford Super Duty Rear Bumper User Manual
Page 4
Installation Instruction RSEI 115
4. Remove all wiring from rear of factory bumper
5. Install factory sensors in new bumper. The sensors read in a specific direction, so they need
to be installed in the same location in the bumper they were removed from. They also need
to be rotated in the hole to face the same direction. After the bumper is reinstalled, test the
sensors to make sure they read correctly by putting the truck in reverse and backing up to an
object. If needed they can be rotated in the hole.
6. Install factory 7 way plug in new bumper