Rock-Slide Engineering RIDGE FRONT BUMPER BULL BAR LIGHT KIT - Manual (Page 2)

Installation Instruction RSEI 116
INSTALLATION
1. You may want to pull a dummy wire through the bulbar to help you get the
wires pulled.
Feed the supplied white wire through the bottom of the Bull Bar and out the
small rear hole in the underside of the top. There is a center hole in both ends
of the Bull Bar designed for wires. The Bull Bar comes with a plastic plug in
the wire hole to keep moisture out of the Bull Bar. If the Bull Bar is off the
bumper, the plastic plug can be removed. If the Bull Bar is attached to the
bumper, you will need to drill the plastic plug out from inside the bumper
where the Bull Bar attaches. Use a butt connector to connect the white wire
from the LED light to the white wire you fed through.
2. Feed supplied black wire through Bull Bar and out the front hole. Pull the
black LED wire out the top hole as well. Attach female connectors to both
black wires.
3. Plug female plugs on black wires into each side of the switch.