Rock-Slide Engineering JK4 SLIDER - Manual (Page 3)

Installation Instruction RSEI 109
b. If no crimping tool is available, follow these instructions
i. Install by using a 5/16’’x1.125’’ minimum length bolt with a 3/8’’
nut
ii. Put a small amount of grease on the bolt to reduce friction
iii. Hold the nut steady with an end wrench so the flange of the insert
is flush against the body panel
iv. Tighten the bolt against the nut to crimp the nutsert into place
v. If the nutsert is rotating, place a star-lock washer between the
3/8’’ nut and nutsert
vi. Once the nutsert is crimped into place completely back out the
bolt
vii. If the nutsert ever breaks loose and spins, repeat the process and
crimp it tighter to prevent spinning
(Nutserts that have been installed correctly)
11. Lift the slider into its final position by inserting the 3 forks on the slider onto the
3 body mount bolts and aligning it against the Jeep rocker face
a. Attach the slider to the rocker face using the 5/16” button head bolts &
washers
i. Start from the center of the slider and work out towards the ends
ii. Apply a small amount of anti-seize to the threads of each bolt
iii. You will be using 5 bolts/washers per side
iv. We recommend tightening the button heads by hand to prevent
any damage to the head of the bolt
b. Tighten the body mount bolts beneath the Jeep to fully secure the slider
i. Make sure the spacer is in between the body and the slider on the
front body mount
ii. The body mount bolts need to be SNUG to the Jeep frame but DO
NOT OVER TIGHTEN the body mount bolts.