Rock-Slide Engineering JEEP JK4 STEP SLIDER - Manual (Page 3)

Installation Instruction RSEI 106
STEP SLIDER INSTALLATION
1) Remove the stock rocker guards if equipped
2) Remove the front body bolts on the driver and passenger side (under the front door)
3) Loosen the rear body bolts (under rear passenger doors)
4) DO NOT REMOVE THESE BOLTS! You will need these bolts to support the slider you are
about to put into place on the Jeep
REAR FRONT
5) Replace the front body bolts on the driver and passenger sides with the 130mm bolt,
aluminum spacer, and large washer in same sequence as the picture below indicates
a) DO NOT completely tighten the bolts, but leave them loose to reflect the same looseness
of the 2 rear bolts so you can fit the slider forks into these slots
6) Move the slider into it’s position on the Jeep
a) You may want some help so that you can support the weight of the slider
b) Take extra care when positioning the slider on the Jeep to prevent any scratching or
marring of the painted surface